Fujitsu PRIMERGY Econel 200 S2 Manuel de supplément de service - Page 33
Parcourez en ligne ou téléchargez le pdf Manuel de supplément de service pour {nom_de_la_catégorie} Fujitsu PRIMERGY Econel 200 S2. Fujitsu PRIMERGY Econel 200 S2 39 pages.
Imprimer la page
Replacement routines
Ê Unpack the new system board, place it on an antistatic surface and check
the settings (for description see the Technical Manual for the system board).
Ê Insert the system board into the housing by holding it at a slight angle and
sliding the connectors into the connector panel.
Ê Carefully place the system board into the housing. Make sure there are no
cables jammed under the system board.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion.
I
When the system board is in the right position the centering ring engages
in the hole indicated (see red circle in figure 15 on page 32).
Ê Fasten the system board with the 6 screws.
Ê Connect all cables to the system board (see cabling in the Options Guide).
Ê Install the processor(s), the heat sink(s) and the memory modules onto the
new system board.
Ê Insert all expansion boards in the relevant slots and connect the cables (for
a detailed description see the Options Guide).
Ê Return the server to its original installation location.
Ê Install the processor fan 1 (for a detailed description see the Options Guide).
Ê Install the memory air duct (for a detailed description see the Options
Guide).
Ê Install the system fan (for a detailed description see the Options Guide).
Ê Install the processor fan 2 (for a detailed description see the Options Guide).
Ê Close the server (for a detailed description see the Options Guide) and
connect the power plug.
Ê Connect all external cables.
V
CAUTION!
After installing the new system board, it is necessary to update the BIOS
to ensure proper operation (for description see the BIOS Manual).
Econel 200 S2
Service Supplement
Replacing the system board
33