Fujitsu Primergy TX120 Manuel de démarrage - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Fujitsu Primergy TX120. Fujitsu Primergy TX120 8 pages.
Également pour Fujitsu Primergy TX120 : Manuel de supplément de service (38 pages)

Imprimer la page

Turning on the power and setting hardware

Normally, hardware settings are not required to be changed from the default.

However, when performing the remote installation or installing the optional devices, start up the BIOS

Setup Utility and check/change hardware settings.

"Chapter 8 Configuring Hardware and Utilities"

You can write down hardware configuration and setting values of the BIOS Setup Utility in the "Configuration

Sheets" that is available from Fujitsu PRIMERGY website (http://primergy.fujitsu.com).

Power on the peripheral devices, such

as the display.

Open the drive cover.

1. Turn the drive cover key counterclockwise

to unlock the cover.

2. Tilt the drive cover downward.

��

For the use of Linux distribution with this server, refer to Fujitsu PRIMERGY website

(http://primergy.fujitsu.com).

Turn on the power and insert the

ServerStart Disc 1 CD-ROM immedi-

ately.

��

Set the hardware.

If no hardware settings are performed, skip to the

next step when a message to insert the ServerStart

floppy disk is displayed.

●BIOS Setup Utility

1. When the "<F2> BIOS Setup / <F12>

Boot Menu" message appears at the server

start up (during POST), press the [F2]

key.

2. Check/change the settings.

3. Select "Save Changes & Exit" from the

Exit menu and press the [Enter] key.

��