Fujitsu SPARC Enterprise M8000 Notes sur le produit - Page 32
Parcourez en ligne ou téléchargez le pdf Notes sur le produit pour {nom_de_la_catégorie} Fujitsu SPARC Enterprise M8000. Fujitsu SPARC Enterprise M8000 44 pages. For xcp version 1041
Également pour Fujitsu SPARC Enterprise M8000 : Manuel de démarrage (4 pages), Caractéristiques Manuel (30 pages), Manuel complémentaire (36 pages)
Imprimer la page
Specific Issues and Workarounds Concerning Solaris (Continued)
TABLE 6
CR ID
Description
6449315
The Solaris cfgadm(1M) command does not
unconfigure a DVD drive from a domain on a
SPARC Enterprise M8000/M9000 server.
6459540
The DAT72 internal tape drive on SPARC
Enterprise M8000/M9000 may time out during
tape operations.
6466617
Performing a hot plug operation with the PCI-
Express slot too quickly interrupts a PCI leaf
reset and fails, creating a cfgadm: Component
system is busy error.
6472153
If you create a Solaris Flash archive on a non-
SPARC Enterprise M8000/M9000 sun4u server
and install it on a SPARC Enterprise
M8000/M9000 sun4u server, the console's TTY
flags will not be set correctly. This can cause
the console to lose characters during stress.
6481002
Installing the Solaris from the network using
certain PCI-Express cards may cause a panic.
22
SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1041 • October 2007
Workaround
Disable the Volume Management Daemon
(vold) before unconfiguring a DVD drive with
the cfgadm(1M) command.
To disable vold, stop the daemon by issuing
the command /etc/init.d/volmgt stop.
After the device has been removed or inserted,
restart the daemon by issuing the command
/etc/init.d/volmgt start.
Add the following definition to
/kernel/drv/st.conf:
tape-config-list=
"SEAGATE DAT
DAT72-000",
"SEAGATE_DAT____DAT72-000",
"SEAGATE_DAT____DAT72-000";
SEAGATE_DAT____DAT72-000=
1,0x34,0,0x9639,4,0x00,0x8c,0x8c,
0x8c,3;
There are four spaces between SEAGATE DAT
and DAT72-00.
Pause a few seconds between the issue of each
cfgadm -c command.
Just after installing Solaris OS from a Solaris
Flash archive, telnet into the SPARC Enterprise
M8000/M9000 server to reset the console's TTY
flags a follows:
# sttydefs -r console
# sttydefs -a console -i "9600 hupcl
opost onlcr crtscts" -f "9600"
This procedure is required only once.
If you are using a Sun PCI-E Dual Gigabit
Ethernet Adapter MMF card or a Sun PCI-E
Dual Gigabit Ethernet Adapter UTP card, do
not install the Solaris using either of these
cards. Instead, use other network devices, such
as the onboard Gigabit Ethernet or another
network device.