Fujitsu SPARC ENTERPRISE T5220 Manuel de démarrage - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Fujitsu SPARC ENTERPRISE T5220. Fujitsu SPARC ENTERPRISE T5220 12 pages. Sparc enterprise
Également pour Fujitsu SPARC ENTERPRISE T5220 : Manuel de synthèse (34 pages), Manuel de planification du site (26 pages), Manuel de sécurité et de conformité (34 pages)
Imprimer la page
Quick Setup Instructions
1. Unpack the server, and check that you received all of the shipping contents (
2. Place the server in its intended location for verification.
For rackmounting instructions, refer to the instructions included with the rail kit, the service label on the
server, and to the online SPARC Enterprise T5120 and T5220 Servers Installation Guide.
3. Connect a serial cable between the server's SER MGT port (
This connection provides your initial communication with the SP.
The device must be set up to communicate using 9600 baud, 8 bit, no parity, 1 stop bit. A null modem
configuration is needed, meaning the transmit and receive signals are reversed (crossed over) for DTE to
DTE communications. You can use the supplied RJ-45 crossover adapters with a standard RJ-45 cable to
achieve the null modem configuration.
Server Connections
FIGURE 2
4. (Optional) Connect an Ethernet cable between the server's NET MGT port (
which future connections to the SP and host will be made.
After the initial configuration of the system using the SER MGT port, communication with the SP and host is
usually performed through this Ethernet interface.
5. Connect an Ethernet cable between one of the server's NET ports (
server will communicate.
FIGURE 1
) and a terminal device.
FIGURE 2
FIGURE 2
) and the network to which the
FIGURE 2
).
) and the network to