Fujitsu fi 5750C - Document Scanner Procédures d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Procédures d'installation pour {nom_de_la_catégorie} Fujitsu fi 5750C - Document Scanner. Fujitsu fi 5750C - Document Scanner 3 pages. Image scanner
Également pour Fujitsu fi 5750C - Document Scanner : Pour commencer (40 pages), Manuel de procédures d'installation (7 pages), Manuel de procédures d'installation (9 pages), Spécifications (2 pages), Manuel de démarrage (42 pages), Brochure & Specs (2 pages), Manuel d'instruction (11 pages), Instructions de remplacement et de nettoyage des consommables (19 pages), Instructions de nettoyage (2 pages), Nettoyage et entretien (39 pages), Instructions de nettoyage (2 pages)

Fujitsu SCSI (650) VRS

Step D: Connecting the Scanner.

Warning! Before proceeding ensure that the power is off when connecting or

disconnecting the SCSI cable to the scanner or workstation. Failure to follow the

procedure above could result in damage to the SCSI card, scanner, and/or your system.

Termination and the SCSI ID's for the scanners are handled automatically.

Connect the SCSI cable to the Kofax controller and to the Wide SCSI (68-pin)

port on the scanner. Ensure all connections are securely fastened.

Connect the power cord to the scanner and a wall outlet. Turn on the scanner

first and when it reports ready boot up your PC. Complete the new hardware

found wizard and go to the next step.

Step E: Scanning with VCDEMO32P.

1. Go to Start, Programs, Kofax VRS or Kofax Image Controls, and select

VCDEMO32P.EXE.

2. Next go to Source, Scanner, and click on the drop down arrow; then

select your scanner model. I.E. Fujitsu fi-4860C with VRS with AIPE.

Wait a few seconds for the Kofax engine to load, and then place your

documents in the scanner.

3. Now go to Source, Properties and select your scanning parameters (i.e.

scan source - Flatbed or ADF, resolution, paper size).

4. You may also access the VRS configuration settings at this time by clicking

on Advance Properties. The AIPE functions are access via the Imaging

menu.

5. Afterwards go to Source, and click on Process Image for single page scans

or Process Batch for multi-page batch scans.

Congratulations! You have successfully completed and tested your VRS scanner

installation.

Step F: Installing third party software applications.

After you have successfully installed all the Fujitsu software and hardware, then it is time

to install any additional third party scanning software that you wish to use. Please follow

the software manufacturer's instructions for installation. Remember when installing any

software that contains Kofax's Image Controls pay close attention to the individual

runtimes. It is strongly recommended that you install the oldest/lower runtime

application first.

Rev052206A

Scanner Installation Procedures

Windows ME\2000\XP

Page 3 of 3