Fujitsu fi-5120C Manuel de démarrage - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Fujitsu fi-5120C. Fujitsu fi-5120C 29 pages. Cleaning and consumable replacement instructions
Également pour Fujitsu fi-5120C : Pour commencer (28 pages), Manuel de procédures d'installation (7 pages), Manuel de procédures d'installation (9 pages), Spécifications (2 pages), Manuel d'instruction (13 pages)

Imprimer la page

2.2 Connecting the Scanner to

Your PC

This scanner is provided with two inter-

ATTENTION

faces: Ultra SCSI and USB 2.0 /1.1. Con-

nect only one of the USB or SCSI interface

cable.

■ Connecting with the USB Interface

Cable

1. Connect the USB interface cable to the USB

interface connector.

2. Connect the other end of the USB interface

cable to the PC.

•

Be sure to use the USB cable which

ATTENTION

comes as an accessory with this scan-

ner.

Scanning operation with commercially

available cables is not guaranteed.

•

When connecting to an USB hub, use

the first stage USB hub that is closest to

the computer. If you use the second or

later hub stages, the scanner may not

operate correctly.

•

If you connect the scanner with USB 2.0,

it is required that the USB port and Hub

are compliant with USB 2.0. The scan-

ning speed may slow down if it is con-

nected with USB1.1.

fi-5120C/fi-5220C Image Scanner Getting Started

■ Connecting with the SCSI Inter-

face Cable

When using the scanner with SCSI interface, a commer-

cially available SCSI interface cable and SCSI card must

be purchased in addition.

• SCSI interface cable:

Use a connector which complies with Ultra

SCSI. A 50 Pin Contact Shielded High-Density

SCSI Device Connector is required.

• SCSI card:

Find the recommended SCSI card information in

the Fujitsu web site (FAQ).

http://imagescanner.fujitsu.com/

•

When connecting the SCSI interface

ATTENTION

cable, turn the scanner off. Be sure to

first connect the SCSI interface cable

and, then turn on the power of the scan-

ner and the personal computer.

•

In a SCSI daisy chain formation, con-

nect the scanner so that it is the termi-

nated device.

1. Insert the SCSI interface cable into the inter-

face connector until both sides click.

2. Connect the other end of the cable to the per-

sonal computer.

Be careful not to bend the pins of the SCSI

ATTENTION

cable when connecting to the scanner .