Fujitsu FI-5530C2 Manuel de démarrage - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Fujitsu FI-5530C2. Fujitsu FI-5530C2 27 pages. Image scanner
Également pour Fujitsu FI-5530C2 : Pour commencer (28 pages), Manuel de procédures d'installation (6 pages), Spécifications (2 pages), Manuel de démarrage (11 pages), Instructions de nettoyage (2 pages), Instructions de nettoyage (2 pages), Pour commencer (11 pages)

2.4 Checking Scanner Driver

Operation

This section explains how to check the operation of the

installed scanner driver by using ScandAll PRO.

Make sure that the scanner driver is installed properly,

following the procedure below.

■ Checking the Operation of the

Scanner Driver

1. Load the document on the scanner.

For information about how to load the document,

refer to section 1.2 in fi-5530C2 Operator's

Guide.

2. Launch ScandAll PRO.

From the [start] menu, select [All Programs] ->

[Fujitsu ScandAll PRO] -> [Fujitsu ScandAll

PRO].

⇒

ScandAll PRO starts up.

3. In ScandAll PRO, select [Tool] on the menu,

and then select [Preferences].

⇒

The [Setup] dialog box appears.

4. On the [Scan] tab, select a driver.

To check the operation of FUJITSU TWAIN 32,

select [TWAIN].

To check the operation of FUJITSU ISIS, select

[ISIS].

5. Click the [OK] button to close the [Setup] dialog

box.

6. In ScandAll PRO, select [Scan] on the menu,

and then select [Select Scanner].

7. Select a scanner in the displayed dialog box.

To use FUJITSU TWAIN 32:

Select [FUJITSU fi-5530C2dj], and then click the

[Select] button.

To use FUJITSU ISIS:

Select [Fujitsu fi-5530C2] and then click the

[Select] button.

8. Select [Scan] on the menu, and then select

[Scan Settings].

fi-5530C2 Image Scanner Getting Started