Fujitsu fi-5650C Manuel de démarrage - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Fujitsu fi-5650C. Fujitsu fi-5650C 40 pages. Image scanner
Également pour Fujitsu fi-5650C : Manuel de procédures d'installation (7 pages), Manuel de procédures d'installation (9 pages), Procédures d'installation (3 pages), Spécifications (2 pages), Brochure & Specs (2 pages), Manuel d'instruction (11 pages), Instructions de remplacement et de nettoyage des consommables (19 pages), Instructions de nettoyage (2 pages), Nettoyage et entretien (39 pages)

Imprimer la page
Fujitsu fi-5650C Manuel de démarrage
1.1 Checking the contents of
scanner package
When you unpack the scanner package, make sure
that the package contains all the parts on the list
included in the package.
If any parts are missing or defective, contact your
sales representative. Handle the scanner and
accessories with care.
1.2 Names and functions of
parts
This section describes the names of parts and their
functions .
No.
Name
1
Operator Panel
2
ADF Paper
Chute
3
ADF Paper
Chute
Extension
4
Side Guide
1-2
TABLE 1.
Function
This panel consists of a
Function No. display,
four operating push
buttons and a LED.
Operation can be
conducted from either of
two sides of the scanner.
Can be closed and
compactly stored when
not in use.
Holds in place the
document pages / sheets
that feed into the ADF.
Please pull out when
scanning a long size
sheet.
It is adjusted to the width
of the paper in order not
to scanned skewed pages.
TABLE 1.
No.
Name
5
Side guide
button
6
ADF Button
7
ADF
(Automatic
Document
Feeder)
8
Stacker
9
Stacker
Extension /
Stopper
TABLE 2.
No.
Name
10
SCSI Interface
Connector
11
SCSI ID
Switch
Function
Used for adjusting the
side guides.
Press this button to open
the ADF.
It transports a document
to the reading position
automatically.
Scanned documents are
ejected from the ADF
onto this tray. It is
possible to change the
height.
Pull out and set the
stopper to the paper
length.
Function
Used for connecting a
SCSI interface cable
from a PC.
Used for setting SCSI ID
(The setting at the factory
shipment is ID=5).