Fujitsu fi-5650C Nettoyage et entretien - Page 28

Parcourez en ligne ou téléchargez le pdf Nettoyage et entretien pour {nom_de_la_catégorie} Fujitsu fi-5650C. Fujitsu fi-5650C 39 pages. Image scanner
Également pour Fujitsu fi-5650C : Manuel de procédures d'installation (7 pages), Manuel de procédures d'installation (9 pages), Procédures d'installation (3 pages), Spécifications (2 pages), Brochure & Specs (2 pages), Manuel de démarrage (40 pages), Manuel d'instruction (11 pages), Instructions de remplacement et de nettoyage des consommables (19 pages), Instructions de nettoyage (2 pages)

Imprimer la page
Fujitsu fi-5650C Nettoyage et entretien
CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
6.1 Removing jammed documents
6.2 Indications of operator panel for errors
6.3 Items to check before contacting the dealer where you
bought the scanner
6.4 Checking labels on the scanner
7 ONLINE SETUP
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
Symptom
: The scanning does not start.
Back to the trouble shooting index
Are the documents loaded correctly on the ADF paper chute?
YES
Is the ADF closed completely?
YES
Is the interface cable connected correctly?
YES
Is the connector of interface cable broken?
NO
(When using the scanner on SCSI interface) Is the SCSI ID set
correctly?
YES
Does the scanning start after running ON the scanner again?
NO
If you cannot solve the problem after taking measures, check the
items in
"6.3 Items to check before contacting the dealer where
you bought the
scanner" and contact the dealer or an authorized
FUJITSU service provider.
All Rights Reserved, Copyright (C) PFU LIMITED 2004
Load the documents correctly onto the ADF paper chute.
NO
Close the ADF completely.
NO
Connect the interface cable correctly.
Reference
: "Getting Started" 2.2 Connecting the scanner to
NO
your PC
Use a new interface cable and correctly connect it.
YES
Turn OFF the scanner and set the SCSI ID correctly, then turn
ON the scanner again.
Reference
: "Getting Started" 2.2 Connecting the scanner to
NO
your PC
The scanner operation is normal.
YES