Fujitsu fi-680PRF Manuel de l'opérateur - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Fujitsu fi-680PRF. Fujitsu fi-680PRF 26 pages. Imprinter
Imprimer la page
2.2 Operating Test
After installing the print cartridge, check whether
characters can be printed.
For details on the operator panel, refer to the
"fi-6400/fi-6800 Image Scanner Operator's Guide".
1
Press the power button on the scanner front.
The [Ready] screen is shown on the LCD.
2
Place a test sheet on the hopper.
Use A4 or Letter size paper. If the size is smaller
！
！ ！
than A4 or Letter, printing may not successfully
complete.
Confirm that the print cartridge is positioned
within the paper width.
3
Press the [Menu] button.
Menu
Function
/Enter
Send to
Clear
Check
/Pause
/Back
Stop
Scan
Counter
iMFF
Reset
Eject
The [Main Menu] screen is shown on the LCD.
4
Select [22: Test Print] by pressing the [
button, and press the [Function/Enter] button.
The [No. of Sheets Scanned] screen is shown
on the LCD.
If the Imprinter is disconnected or not connected
！ ！
！
properly, [Cannot use this function because the
Imprinter is not connected.] is shown on the LCD.
5
Select [1: Single Sheet Only] or [2: Multiple Sheets]
by pressing the [
[Function/Enter] button.
When [2: Multiple Sheets] is selected, printing is
performed for all sheets set in the hopper.
The [Print] screen is shown on the LCD.
When only either the Front-Side Imprinter or Back-
！
！ ！
Side Imprinter is installed in the scanner, the [Print
Pattern] screen is shown on the LCD. Go to Step 7.
] or [
] or [
] button, and press the
6
Select the Imprinter to be used by pressing the [
or [
] button, and press the [Function/Enter]
button.
Select [1: Front Side] for the Front-Side Imprinter, or
[2: Back Side] for the Back-Side Imprinter.
The [Print Pattern] screen is shown on the LCD.
7
Select a print pattern by pressing the [
button, and press the [Function/Enter] button.
The following print patterns are available for vertical
and horizontal orientation.
1:(L)ABCDEFGHIJKLMNOPQRSTUVWXYZ[¥]^_`
00000000
2:(L)abcdefghijklmnopqrstuvwxyz{|}¯ 00000000
3:(L)!"#$%&'()*+,-./
0123456789:;<=>?@00000000
4:(P)ABCDEFGHIJKLMNOPQRSTUVWXYZ[¥]^_`
00000000
5:(P)abcdefghijklmnopqrstuvwxyz{|}¯ 00000000
6:(P)!"#$%&'()*+,-./
0123456789:;<=>?@00000000
When multiple sheets are set in the hopper, printing
is performed for all the sheets.
The section "00000000" begins with 0, and
increases in increments of 1.
]
The [Test Print] screen is shown on the LCD.
8
Select whether to run a test print by pressing the
[
] or [
button.
The test sheet is fed into the ADF, and the
Imprinter prints out the Print Test Characters
starting at 5 mm (±4 mm) from the paper's edge.
13
] button, and press the [Function/Enter]
]
] or [
]