Fujitsu ScanSnap FI-4110EOX2 Manuel de démarrage - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Fujitsu ScanSnap FI-4110EOX2. Fujitsu ScanSnap FI-4110EOX2 18 pages. Color image scanner
Également pour Fujitsu ScanSnap FI-4110EOX2 : Procédures d'installation (2 pages), Spécifications (2 pages)
Imprimer la page
Symptom
The image is printed white or dark.
1
Double-feed
frequently occurs.
Paper is not fed (stops midway).
The scanner is not recognized even
if ScanSnap! Driver is installed.
The size of the scanned image file
is the same as that for a color
document even though you are
scanning a Black & White (B&W)
document.
The back side of the document
appears in the scanned image when
scanning a two-sided document
(noise of back side image).
4.2. Clearing Paper Jams
1.
Remove all from the ADF paper chute.
2.
Open the ADF while lifting up the cover open lever. Then remove the jammed documents from the paper path.
3.
Push in the center of the ADF to return it to its original position.
ADF
You should hear the ADF click when it returns to its original position.
1
"Double-feed" is a phenomenon where two or more sheets are fed into the scanner in a single operation.
Check This Item
In Black &White (B&W) scanning,
is [Option...] - "Brightness" in the
[Scanning] tab set extremely Light or
Dark?
Is the Pad ASSY dirty?
Is the Pad ASSY worn?
Is the document stack thicker than 4
mm?
Is the Pick roller dirty?
Is the Pick roller worn?
Is there debris on the document feed
path?
Was the scanner connected to your
computer before ScanSnap! Driver was
installed?
Is the scanner registered as "Other
device" in the "Device Manager"?
Is the B&W document being scanned in
the color mode?
Is the "Allow automatic noise
reduction." checkbox unmarked at
[Option...] on the [Scanning] tab in the
"Scan and Save Settings" screen.
Cover open lever
Adjust "Brightness" at [Scanning] -
[Option...] in the "Scan and Save
Settings" window.
Clean the pad following the instructions
in "6.2. Cleaning the ADF".
Clean the Pad ASSY following the
instructions in "5.2. Replacing the Pad
ASSY".
Reduce the number of sheets in the
document sheet to 4 mm thickness or
less.
Clean the Pick roller following the
instructions in "6.2. Cleaning the ADF".
Clean the Pick roller following the
instructions in "5.3. Replacing the Pick
Roller".
Remove any debris from the document
feed path.
On the [Start] menu, select [Control
panel] - [System] - [Hardware] -
[Device Manager]. Delete the "Other
Device" selection in the [Device
Manager] and restart your computer.
Set [Color mode:] on the [Scanning] tab
in the "Scan and Save Settings" screen
to "B&W".
Mark the "Allow automatic noise
reduction." checkbox.
Push in center.
ScanSnap! fi-4110EOX2 Getting Started | 11
Remedy