Fujitsu ScanSnap fi-5110EOXM Pour commencer - Page 7
Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} Fujitsu ScanSnap fi-5110EOXM. Fujitsu ScanSnap fi-5110EOXM 24 pages. Color image scanner for macintosh
Également pour Fujitsu ScanSnap fi-5110EOXM : Procédures d'installation (3 pages), Brochure & Specs (2 pages)
Imprimer la page
1. Preparation
This chapter describes necessary preparations before using
ScanSnap.
Do not connect the scanner to your PC
ATTENTION
before installing "ScanSnap Manager".
If the scanner is connected before installing
ScanSnap Manager, it will not operate
correctly.
Refer to Chapter 2 for the installation of
ScanSnap Manager.
1.1. Checking the Contents of the
Package
When you unpack the scanner package, make sure that all
parts are included.
Refer to the package contents list included the scanner
package box.
1.2. Names and Functions of Parts
This section describes the names and functions of parts.
Front Side
Paper chute cover
Open this cover when using
the scanner.
→ Opening the cover turns
ON the scanner.
ADF cover
(ADF: Automatic Document Feeder)
Stacker
Place the scanner aligning
the two front projection to
the hollows on the bottom
of the scanner.
Cover open lever
Pull this lever to open the ADF
Paper chute cover
Open this cover and load the
documents onto this part when
scanning documents.
Side guide
Adjust these guides to the
documents width for
preventing skewed
images.
Stacker
For using this part, pull it out
as shown in the figure.
→ Documents are ejected from the ADF onto this tray.
* You can also use the scanner without the Stacker.
cover.
Buttons
Buttons
Back Side
USB connector
Seal: After installing ScanSnap Manager onto
your computer, remove this seal to connect the
scanner to the PC.
For the Document Specification, refer to the
HINT
"ScanSnap fi-5110EOXM Operator's
Guide" stored in ScanSnap Setup
CD-ROM.
The scanner turns on/off automatically, when you
ATTENTION
open/close the Paper chute cover.
To turn off the scanner when the cover is open,
press the [POWER] button.
ScanSnap fi-5110EOXM for Macintosh Getting Started | 5
[SCAN] button
Starts scanning.
[POWER] button
Turns on/off the power supply.
Power lamp
Indicates the scanner status.
Blue
:Ready
Blue (Blinking)
:Scanning
Yellow
:Error
Light off
:Power off
AC adapter connector