Fujitsu Eternus DX200F Manuel de configuration - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Fujitsu Eternus DX200F. Fujitsu Eternus DX200F 28 pages. Hybrid storage systems, all-flash arrays, power synchronized unit
Également pour Fujitsu Eternus DX200F : Manuel d'utilisation (48 pages), Manuel de configuration (10 pages), Manuel de configuration (13 pages), Manuel de configuration (16 pages), Manuel de configuration (38 pages), Précautions de sécurité (12 pages)

Imprimer la page
Fujitsu Eternus DX200F Manuel de configuration
Chapter 7
Checking Connections
7.1

Turning on the Devices

To turn on the connected devices, use the following procedure:
1
Turn on any devices (such as LAN switches) on the LAN path between the ETERNUS DX and server.
2
After checking that the Ready (or equivalent) LED of the LAN switch is lit, turn on the ETERNUS DX
storage systems.
3
After checking that the ETERNUS DX's Ready LED is lit, turn on the server.
7.2

Setting Up the Server to Recognize the Logical Units

Make the server recognize the logical units (LUN) set in the ETERNUS DX storage systems.
1
Use the "ioscan" command to check which devices are connected.
Enter as follows for LegacyView (old format) results:
# ioscan -fn
Enter as follows for AgileView (HP-UX11iv3 and newer format) results:
# ioscan -fnN
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX
22
Copyright 2014 FUJITSU LIMITED
P3AM-3402-14ENZ0