Fujitsu ETERNUS DX60 S3 Manuel de planification du site - Page 38
Parcourez en ligne ou téléchargez le pdf Manuel de planification du site pour {nom_de_la_catégorie} Fujitsu ETERNUS DX60 S3. Fujitsu ETERNUS DX60 S3 41 pages. Hybrid storage systems, all-flash arrays, power synchronized unit
Également pour Fujitsu ETERNUS DX60 S3 : Manuel de configuration Connexion au serveur (12 pages), Manuel de configuration (28 pages), Manuel de configuration (13 pages), Précautions de sécurité (12 pages)
Chapter 2
Rack Installation Specifications
2.2
Installable Racks
2.2
Installable Racks
This section explains the racks in which the ETERNUS DX can be installed.
2.2.1
Fujitsu Racks
The ETERNUS DX can be installed in a Fujitsu 19-inch rack. For information about whether the ETERNUS DX
can be installed in an EOLed rack or not, contact your sales representative.
2.2.2
Non-Fujitsu Racks
The ETERNUS DX storage systems are developed and their operation is guaranteed on the assumption that
they are installed in Fujitsu 19-inch racks. Since the ETERNUS DX cannot be tested (for cooling and strength)
in non-Fujitsu 19-inch racks, the operations of ETERNUS DX storage systems cannot be guaranteed. Any
problem that may occur by installing the ETERNUS DX in non-Fujitsu racks is not covered by the warranty.
If the ETERNUS DX needs to be installed in a non-Fujitsu rack, the following conditions must be satisfied.
■
Rack Specifications
Use the rack mount kit supplied with the product to install the ETERNUS DX in the rack. The rack specifica-
tions must satisfy the conditions listed below. For rack specifications, refer to the manual for the rack that is
used.
Pitch for mounting holes
•
EIA Standard Universal pitch
Size for mounting holes
•
The size of the square holes must be 9mm or more.
Load bearing capacity
•
The load bearing capacity must be equal to or larger than the total weight of the ETERNUS DX.
•
Unit Installation Area
The dimensions of the area shown in
Figure 2.6
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Site Planning Guide
Copyright 2015 FUJITSU LIMITED
must match the conditions described in
38
Table
2.3.
P3AM-8982-03ENZ0