AEG ARCTIS Manuel d'utilisation - Page 12

Installation

Electrical Connection

Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety measures

not be observed.

Before switching on, make sure the electricity supply voltage is the

same as that indicated on the appliance rating plate. The rating plate is

inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of

having to change the fuse in the plug supplied, a 13 amp ASTA appro-

ved (BS 1362) fuse must be used.

Important

The wires in the mains lead are coloured in accordance with the follo-

wing code:

Green and Yellow Earth

Blue

Brown

As the colours of the wires in the

mains lead of this appliance may not correspond with the coloured

markings indentifying the terminals in your plug, proceed as follows:

1. The wire coloured green and yellow must be connected to the termi-

nal marked with the letter „E" or by the earth symbol

green and yellow.

2. The wire coloured blue must be connected to the terminal „N" or

coloured black.

3. The wire coloured brown must be connected to the terminal marked

„L" or coloured red.

4. Upon completion there must be no cut, or stray strands of wire pre-

sent and the cord clamp must be secure over the outer sheath.

Warning! A cut-off plug inserted into a 13 amp socket is a serious

safety (shock) hazard. Ensure that the cut-off plug is disposed of safely.

(valid for United Kingdom only)

Neutral

Live

Green

& Yellow

Blue

Brown

Cord Clamp

or coloured