Brother PEDESIGNNEXT Manuel d'installation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Brother PEDESIGNNEXT. Brother PEDESIGNNEXT 16 pages. Sistema de software de bordado
Également pour Brother PEDESIGNNEXT : (Guide d'installation (16 pages)
Imprimer la page
[STEP2] Upgrading the USB Card Writer Module
(For upgrade customer only)
This section describes how to upgrade the USB card writer module for PE-DESIGN NEXT. Users upgrading
from PE-DESIGN version 5, 6, 7 or 8 must upgrade the card writer. After installing PE-DESIGN NEXT,
immediately follow the procedure below to upgrade the card writer for PE-DESIGN NEXT.
a
Note:
• In order to upgrade the USB card writer module, you must be able to connect to the Internet. If you
cannot connect to the Internet, contact your authorized dealer or Brother Customer Service.
• It may not be possible to upgrade if a firewall is turned on. Turn off the firewall, and then try
performing the operation again.
1.
Start up Layout & Editing.
→ The dialog box shown below appears.
2.
To begin the upgrade, click Upgrade now.
→ The Upgrade wizard starts up, and the first dialog box shown below appears.
3.
Click Next.
4.
Type in the 15-digit product ID on the label attached to the CD-ROM case, and then click Next.
a
Note:
• If the product ID is incorrectly entered, the message "The product ID is incorrect. Check that a
mistake was not made during typing." appears.
• The uppercase letters "I" and "O" are not used in the product ID.
• Each product ID is valid for only one USB card writer module.
A product ID that has already been used cannot be used with a different USB card writer module.
10
Before Use