Fujitsu SCANPARTNER 600C Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Fujitsu SCANPARTNER 600C. Fujitsu SCANPARTNER 600C 23 pages. Image scanner
Également pour Fujitsu SCANPARTNER 600C : Manuel de l'utilisateur (25 pages), Instructions de remplacement et de nettoyage des consommables (7 pages), Procédures d'installation (5 pages)

2.1.2

Refitting the Shipping Bracket

Whenever you need to move the Scanner to a new location it is advisable to refit the shipping bracket

to avoid causing damage to the Scanners' internal mechanism. Please follow the instructions below

to refit the shipping bracket.

ii)

Note: For steps (iii) to (vi) please refer to figures 2-1 and 2-2

iii)

iv)

vi)

2.2

When you have several devices on a SCSI chain, you may need to adjust the SCSI ID selector setting located

on the back of the Scanner. This setting assigns a specific "device ID" to the Scanner. If the assignment

conflicts with an existing SCSI device, please select a new ID (see Figure 2.3).

Note:

The factory setting for the Scanner is ID 6. Usually, ID 0 is assigned to an internal hard disk drive,

and ID7, to SCSI adapter or host. ID 8 and 9 are not in actual use.

Using a suitable tool, turn the selector switch until the arrow points to the desired ID number.

Turn off the Scanner power at the power on/off switch.

Disconnect all cables.

Carefully place the Scanner in an upright position on its front side.

Using a suitable screwdriver remove the screw holding the shipping bracket in the use

position.

Put the shipping bracket into the shipping position, with the long side extending into the

Scanner base. Secure it with the screw.

Carefully place the Scanner back into its normal position.