Fujitsu ScanPartner 620C Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Fujitsu ScanPartner 620C. Fujitsu ScanPartner 620C 28 pages. Image scanner
Également pour Fujitsu ScanPartner 620C : Spécifications (2 pages), Instructions de remplacement et de nettoyage des consommables (7 pages), Procédures d'installation (5 pages)

2.1.2 REFITTING THE SHIPPING BRACKET

Whenever you need to move the scanner to a new location, it is advisable to refit the shipping

bracket to avoid causing damage to the scanners' internal mechanism. Please follow the

instructions below to refit the shipping bracket.

i). Turn off the scanner power at the power On/Off switch.

ii). Open the document cover.

Note: For steps (iii) to (v) please refer to Figure 2-1 and 2-2.

iii). Carefully place the scanner in an upright position on its front side.

iv). Use a suitable screwdriver to remove the screw holding the shipping bracket in the USE

position.

v). Put the shipping bracket into the shipping position, with the long side extending into the

scanner base. Secure it with the screw.

vi). Carefully place the scanner back into its normal position.

When you have several devices on a SCSI chain, you may need to adjust the SCSI ID selector

setting located on the back of the scanner. This setting assigns a specific "device ID" to the

scanner. If the assignment conflicts with an existing SCSI device, please select a new ID. (See

Figure 2-3)

Note: The factory setting for Scanner is ID 6. Usually, ID 0 is assigned to an internal hard disk drive,

and ID 7, to SCSI adapter or host. ID 8 and 9 are not in actual use.

Using a suitable tool, turn the selector switch until the arrow points to the desired ID number.

2-4