Brother Quattro 6000D Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Brother Quattro 6000D. Brother Quattro 6000D 42 pages. Kit de actualización iii
Également pour Brother Quattro 6000D : Manuel d'utilisation (50 pages), Manuel d'utilisation (6 pages), Manuel de l'utilisateur (48 pages), Manuel d'utilisation (29 pages), Manuel d'utilisation (21 pages), (anglais) Instruction Manual (49 pages), (anglais) Instruction Manual (21 pages), (anglais) Instruction Manual (48 pages)

Brother Quattro 6000D Manuel
Brother
General
Sewing
Accessories
09

Narrow Hemmer Foot

Non Stick Foot
Skirt
Innov-is Project Book
(See page 50 for details.)
Narrow Hemmer Foot
Designed to create a flat narrow hem on lightweight fabrics.
1. Place the fabric with the wrong side facing up under the presser foot.
2. Lower the needle into the fabric approximately 1/8" from the edge and sew 2-3 stitches.
3. Raise the needle and the presser foot.
4. Hold the fabric from the back and front and roll it into the curled part of the foot.
5. Position the edge of the fabric behind the needle and lower the presser foot.
6. Slowly sew 2-3 stitches, making sure the fabric is rolling around the curled part of the foot.
7. Continue to sew to the end of the fabric.
SA126
SA127
ABCDEFJKMN
GHILOP
Non Stick Foot
Designed for consistent feeding with fabrics such as leather, vinyl and
other novelty fabrics.
Select a desired stitch and sew.
SA114
SA122
ABCDEFGHJKLMNO
IP
Travel Jewelr y Portfolio
Innov-is Project Book
(See page 53 for details.)
Overlock Foot
For vertical bobbin machines only.
Sews overcast seams to protect edges from fraying.
1. Select an overlock stitch.
2. Attach the presser foot.
3. Lower the presser foot so that the foot guide is exactly against the edge of the fabric.
4. Sew along the guide.
Picot Foot
Creates shell-looking edges on sheer and very lightweight fabrics.
1. Increase upper thread tension.
2. Place the fabric with the wrong side facing up under the presser foot.
3. Lower the needle into the fabric approximately 1/8" from the edge and sew 2-3 stitches.
4. Raise the needle and the presser foot.
5. Hold the fabric from the back and front and roll it into the curled part of the foot.
6. Position the edge of the fabric behind the needle and lower the presser foot.
7. Slowly sew 2-3 stitches, making sure the fabric is rolling around the curled part of the foot.
8. Continue to sew to the end of the fabric.
Brother
General
Sewing
Accessories
Overlock Foot
10
Picot Foot
SA135
GHILOP
SA164
SA149
ABCDEFJKMN
GHILOP
www.brother.com