Indesit IWME 146 Manuel d'utilisation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Indesit IWME 146. Indesit IWME 146 20 pages.

Imprimer la page

Troubleshooting

Your washing machine could fail to work. Before calling for Assistance (see page 16), make sure the problem can't easily be

solved by consulting the following list.

Problem

The machine does not switch on.

The wash cycle does not start.

The machine does not fill with

water.

The machine continuously fills

with water and continually drains

away or Water left in the dru or

Stuck on wash.

The machine does not drain or

spin.

The machine does not heat or

poor wash results.

The programme takes too long.

The machine vibrates a lot during

the spin cycle.

Possible causes/Solution:

• The appliance is not plugged into the socket fully, or not enough to make

contact.

• There is no power to the socket, or the fuse has blown in the mains plug.

• The door is not closed properly.

• The 'ON/OFF' button has not been pressed.

• The 'START/RESET' button has not been pressed.

• The water tap has not been turned on to allow water to flow into the machine.

• A delayed start has been set.

• The water inlet hose is kinked.

• The water inlet hose is not connected to the water supply.

• The water pressure is too low.

• The water tap has not been turned on to allow water to flow into the machine.

• There is no water supply to the house.

• The inlet valve filter is blocked.

• The 'START/RESET' button has not been pressed.

• The top of the drain hose is too low - It must be fitted at a height between

65 and 100 cm from the floor.

• The drain hose is connected incorrectly to the sink trap allowing water to

run into the machine, the drain hose must be positioned higher than the

bottom of the sink to prevent water flowing down the drain hose.

• The end of the drain hose has been pushed too far down the standpipe, the

'U' bracket should be fitted 100 mm from the end of the drain hose.

• The Pump filter is blocked.

• The "Easy iron" function is enabled: to complete the programme,

press the START/RESET button (see page 13).

• The drain hose is kinked.

• New Installation - The blanking cap or spigot has not been removed

if connected under a sink.

• The drain hose or sink trap is blocked.

• The wash cycle does not include draining, some wash cycles require

the drain phase to be started manually.

• The 'Spin Speed' selector knob is in the

• The 'Temperature' selector knob is in the

• Programme times will vary due to water pressure, the incoming water

temperature and if the wash load goes out of balance. This will increase

the programme times accordingly (see ' The machine wont spin properly'

below).

• The feet have not been adjusted, enabling the machine to rock.

• New Installation - Either the Transit Bolts including the plastic spacers, or the

Polystyrene Packaging have not been removed when installing the machine.

• The machine is trapped between cabinets and/or walls.

• The load is in a slight out of balance condition and machine is spinning, but

at a lower speed.

position.