Indesit CAA 55 NF Manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Indesit CAA 55 NF. Indesit CAA 55 NF 12 pages. Refrigerator/freezer combination

Imprimer la page

Troubleshooting

If the appliance does not work, before calling for Assistance ( see Assistance ), check for a solution from the following list.

Malfunctions:

The POWER indicator light does not

illuminate.

The refrigerator and the freezer do

not cool well.

The food inside the refrigerator is

beginning to freeze.

The motor runs continuously.

The appliance makes a lot of noise.

There is water at the bottom of the

refrigerator.

Some of the external parts of the

refrigerator become hot.

The back wall of the refrigerator

unit is covered in frost or droplets

of water.

There is water at the bottom of the

refrigerator.

Icing water at rear of the Fridge

Excess moisture / Ice at rear of the

Fridge

Warm Fridge

Possible causes / Solutions:

• The plug has not been inserted into the electrical socket, or not far

enough to make contact, or there is no power in the house.

• The doors do not close properly or the seals are damaged.

• The doors are opened too frequently.

• The TEMPERATURE ADJUSTMENT knob is not in the correct position

• The refrigerator or the freezer have been over-filled.

• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

• The food is in contact with the back inside wall of the refrigerator.

• The door is not closed properly or is continuously opened.

• The outside ambient temperature is very high.

• The thickness of the frost exceeds 2-3 mm ( see Maintenance ).

• The appliance has not been installed on a level surface ( see

Installation ) .

• The appliance has been installed between cabinets that vibrate and

make noise.

• The internal refrigerant makes a slight noise even when the

compressor is off. This is not a defect, it is normal.

• The water discharge hole is blocked ( see Maintenance ).

• These raised temperatures are necessary in order to avoid the

formation of condensation on certain parts of the product.

• This shows the appliance is operating normally.

• The water discharge hole is blocked ( see Maintenance ).

• Make sure that the "Fast Freeze switch" (see pag 7 for details) is

NOT in the 'ON' position, this will cause 100% run. If switch is not

in ON position and severe icing persists, set temperature

regulating knob (see pag 5 for details) to lower position.

• Excess moisture / Ice will occur if the Larder door is opened for

prolonged periods. This will disappear once the door is closed and

the Larder allowed to defrost and drain the moisture away. This is

normal for cooling function of the Larder compartment, especially

in summer period.

• If room temperature is 7 C or lower, (for example the product is

located in a garage or out building), for the refrigerator to operate

correctly the "Fast Freeze switch" must be in the 'ON' position (see

pag 16 for details)