Indesit K6T21/AUS Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Indesit K6T21/AUS. Indesit K6T21/AUS 12 pages. Indesit k6t21/aus cooker operating instructions

Imprimer la page

AUS

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of

the correct colour as indicated by the coloured

marking or the colour that is embossed in words on

the base of the plug. Replacements can be obtained

directly from your nearest Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded plug

and you should wish to remove it to add a cable

extension or to re-route the mains cable through

partitions, units etc., please ensure that either:

• the plug is replaced by a fused 13 amp re-

wireable plug bearing the BSI mark of approval.

or:

• the mains cable is wired directly into a 13 amp

cable outlet, controlled by a switch, (in

compliance with BS 5733) which is accessible

without moving the appliance.

! ! ! ! ! For appliances with a rating greater than 13 amp

(eg: electric hob, double ovens and freestanding

electric cookers etc.) the mains cable must be wired

into a cooker output point with a rating of 45 amp. In

this case the cable is not supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you

make the pins unusable so that it cannot be

accidentally inserted into a socket. Instructions for

connecting cable to an alternative plug:

! ! ! ! ! The wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow

Blue

Brown

If the colours of the wires in the mains lead do not

correspond with the coloured markings identifying

the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked "E E E E E "

or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked "L L L L L " or

coloured Red.

Connect Blue wire to terminal marked "N N N N N " or

coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted

with a 13 amp fuse. A 15 amp plug must be

protected by a 15 amp fuse, either in the plug or

adaptor or at the distribution board. If you are in any

doubt about the electrical supply to your machine,

consult a qualified electrician before use.

- Earth

- Neutral

- Live

How to connect an alternative plug:

The wires in this mains lead are coloured in

accordance with the following code:

GREEN &

YELLOW

13 amp fuse

BROWN

CROSS-BAR

BLUE

CORD GRIP

Disposing of the appliance

When disposing of the appliance please remove the

plug by cutting the mains cable as close as

possible to the plug body and dispose of it as

described above.

Checking the connection for leaks

When the installation process is complete, check

the hose fittings for leaks using a soapy solution.

Never use a flame.

Adapting to different types of gas

It is possible to adapt the

appliance to a type of gas

other than the default type

(this is indicated on the rating

label on the cover).

Adapting the hob

Replacing the nozzles for the hob burners:

1. Remove the hob grids and slide the burners off

their seats.

2. Unscrew the nozzles using a 7 mm socket

spanner ( see figure ), and replace them with nozzles

suited to the new type of gas ( see Burner and nozzle

specifications table ).

3. Replace all the components by following the

above instructions in reverse.

Adjusting the hob burners' minimum setting:

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory

screw, which is positioned inside or next to the tap

pin, until the flame is small but steady.

B L U E

"NEUTRAL

NEUTRAL

NEUTRAL" ("N N N N N ")

NEUTRAL

B R O W N

"LIVE

LIVE

LIVE" ("L L L L L ")

LIVE

GREEN AND

Y E L L O W

"EARTH

EARTH

EARTH" ("E E E E E ")

EARTH