Indesit KD6G25M Manuel d'instructions pour l'installation et l'utilisation - Page 27
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} Indesit KD6G25M. Indesit KD6G25M 32 pages. Free standing gas cooker
Également pour Indesit KD6G25M : Manuel d'utilisation (24 pages), Manuel d'utilisation (24 pages)
Imprimer la page
Installation Instructions
UNPACKING THE COOKER
Unpack the components from inside the grill and oven: Check that the following parts
are present.
Grill pan and grid
Baking dish
Main oven shelves (2)
Top oven/grill shelf (1)
Aluminium burner bodies(4)
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)
Each burner requires the injector to be replaced and bypass screws adjusted or replaced as
follows:
1.
Remove the loose hotplate burner parts.
2.
Using a 7mm socket, replace the hotplate injectors as appropriate (see table on
previous page).
3.
Re-position the loose burner parts.
4.
Remove the screw on the left hand side of the grill burner and gently slide the
burner off the injector.
5.
Using a 7mm socket, replace the grill injector as appropriate (see table on previous
page).
6.
Re-assemble the burner.
7.
Inside the main oven, remove the central screw securing the burner retainer. Slide the
retainer to the right slightly and lift away.
8.
Lift the burner assembly and place on the floor of the oven to the right of the burner
opening.
9.
Using a 7mm socket, replace the oven injector as appropriate (see table on previous
page).
10.
Re-assemble the oven burner and retainer.
11.
Replace the top oven injector following the same procedure as for the main oven.
12.
Carefully pull off the control knobs.
13.
Using a narrow flat bladed screwdriver rotate the bypass screws fully clockwise. The
main oven thermostat bypass screw is located on the body of the thermostat below
the spindle, the top oven thermostat bypass screw is located on the body of the
thermostat to the right of the spindle and the hotplate tap bypass screws are located
down the centre of the spindle.
14.
Re-assemble the control panel parts.
15.
Secure the self-adhesive LPG conversion label over the gas details on the data badge.
Top oven/grill shelf heat shield
Pan supports
Enamelled burner caps (4)
Small pan support trivet
Literature
27