Indesit EWDE 7125 Manuel d'utilisation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Indesit EWDE 7125. Indesit EWDE 7125 16 pages.

Imprimer la page

Installation

! Keep this instruction manual in a safe place for

future reference. Should the appliance be sold,

transferred or moved, make sure the instruction

manual accompanies the washer-dryer to inform

the new owner as to its operation and features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washer-dryer.

2. Check whether the washer-dryer has been

damaged during transport. If this is the case, do

not install it and contact your retailer.

4. Seal the gaps using the plastic plugs provided.

5. Keep all the parts: you will need them again if

the washer-dryer needs to be moved to another

location.

! Packaging materials are not children's toys.

Levelling

Your machine may make a considerable amount

of noise if the two front feet have not been adju-

sted correctly.

1. Install the washer-dryer on a flat sturdy floor,

without resting it up against walls, furniture ca-

binets or other.

correctly will provide it with stability and avoid

3. Remove the 4 pro-

tective screws and the

rubber bush with the

respective spacer, si-

tuated on the rear of the

appliance (see also the

installation leaflet).

2. If the floor is not per-

fectly level, compensate

for any unevenness by

tightening or loosening

the adjustable front feet

(see figure); the angle

of inclination, measu-

red according to the

worktop, must not ex-

ceed 2°.

Levelling your appliance

any vibrations, noise and shifting during ope-

ration. If it is placed on a fitted or loose carpet,

adjust the feet in such a way as to allow enough

room for ventilation beneath the washer-dryer.

Electric and water connections

Connecting the water inlet hose

3. Make sure there are no kinks or bends in the

hose.

! The water pressure at the tap must be within

the values indicated in the Technical details

table (on the page 5).

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Ensure that the supply taps are allowing wa-

ter through. Old taps may seize in the closed

position and thus prevent water reaching the

machine.

1. Connect the supply

pipe by screwing it to

a cold water tap using

a 3/4 gas threaded

connection (see figure).

Before performing the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the other

end of the water inlet

hose to the washer-

dryer, screwing it onto

the appliance's cold

water inlet, situated on

the top right-hand side

on the rear of the ap-

pliance (see figure).