Indesit F160959 Manuel rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Indesit F160959. Indesit F160959 4 pages.

Imprimer la page

WASH CYCLES

Follow the instructions on the symbols of the garment's wash

care label. The value indicated in the symbol is the maximum

recommended temperature for washing the garment.

Mixed

For washing lightly to normally soiled resilient garments in cotton, linen,

synthetic fibres and mixed fibres.

Cotton

Suitable for washing towels, underwear, table cloths, etc. made of

resistant linen and cotton that are moderately to heavily soiled.

Synthetics

Suitable for washing moderately soiled garments made of synthetic fibres

(e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton fibres.

White

For heavily soiled whites and resistant colours.

Colours

A 30°C cycle that helps to preserve colours, suitable for cotton or

synthetic coloured garments. It allows for reducing electricity

consumption for heating the water while guaranteeing good washing

results. Suitable for lightly soiled garments.

Eco 40-60

For washing normally soiled cotton garments declared to be washable at

40 °C or 60 °C, together in the same cycle. This is the standard cotton

programme and the most efficient in terms of water and energy

consumption.

Sport

A cycle designed for washing lightly soiled sports clothing (tracksuits,

shorts, etc.); for best results, we recommend not exceeding the maximum

load indicated in the "Wash Cycle Table". We recommend using liquid

detergent and adding the amount suitable for a half-load.

20 °C

For washing lightly soiled cotton garments, at a temperature of 20 °C.

Anti Odour

use programme for washing garments with bad odours (e.g. smoke,

sweat, fried food). The programme is designed to remove bad odours

while preserving the fabric fibres. Synthetics fabrics or mixed loads should

be washed at 40°, and resistant cotton fabrics at 60°.

Delicates

use programme to wash very delicate garments. It is advisable to turn the

garments inside out before washing them. For best results, use liquid

detergent on delicate garments.

When selecting an exclusively time-based drying function, a drying cycle is

performed at the end of the wash cycle that is particularly delicate, thanks

to light handling and appropriate temperature control of the water jet.

The recommended durations are:

1 kg of synthetic garments --> 150 min

1 kg of synthetic and cotton garments --> 180 min

1 kg of cotton garments --> 180 min

The degree of dryness depends on the load and fabric composition.

Wool - Woolmark Apparel Care - Blue:

The "Wool" wash cycle is approved by the Woolmark

Company for washing wool garments classified as

"hand-washable", provided that the wash complies with

the instructions appearing on the garment's label and

with those provided by the manufacturer of this washer-

dryer (M1126).

Rapid 30'

For washing lightly soiled garments in a short time. Not suitable for wool,

silk and garments to be washed by hand.

Wash&Dry 45 min

select programme for washing and drying lightly soiled garments (Cotton

and Synthetic) in a short time. This cycle may be used to wash and dry a

laundry load of up to 1 kg in just 45 minutes. To achieve optimum results,

use liquid detergent and pre-treat cuffs, collars and stains.

AirFresh

ideal cycle to refresh garments and remove bad odours, in particular

smoke, from cotton and synthetic items in 30' (max 1.5kg) without the

washing phase.

Rinse + Spin

Designed for rinsing and spinning.

Spin + Drain

Designed to spin and drain the water.

Eco cotton

For washing normally soiled cotton garments at 60°C.

WASH CYCLE PHASE INDICATOR LIGHTS

Once the desired wash cycle has been selected and has begun, the

indicator lights switch on one-by-one to indicate which phase of the cycle

is currently in progress.

Wash

Rinse

Spin/Drain

Drying

END End of Wash Cycle

DOOR LOCKED INDICATOR

When lit, the symbol indicates that the door is locked. To prevent any

damage, wait until the symbol turns off before opening the door.

To open the door while a cycle is in progress, press the START/PAUSE

button; if the indicator light is off, the door can be opened.

FIRST-TIME USE

Once the appliance has been installed, and before it is used for the first

time, run a wash cycle with detergent and no laundry, by setting the

"Auto-Clean" cycle.

DAILY USE

Prepare the laundry by following the suggestions appearing under the

"TIPS AND SUGGESTIONS" section.

Rapid programming

- Turn the washer-dryer on by pressing the ON/OFF

indicator lights will light up for a few seconds, then only the lights

corresponding to the settings for the selected wash cycle will remain lit;

the START/PAUSE

indicator light will also flash.

- Open the door. Load the laundry while making sure not to exceed the

maximum load quantity indicated in the cycle table.

- Pull out the detergent dispenser drawer and pour the detergent into the

relevant compartments as described in "DETERGENT DISPENSER DRAWER

section".

- Close the door.

- Press the PUSH & GO button to start the wash cycle.

Traditional programming

- Turn the washer-dryer on by pressing the ON/OFF

indicator lights will light up for a few seconds, then only the lights

corresponding to the settings for the selected wash cycle will remain lit;

the START/PAUSE

indicator light will also flash.

- Open the door. Load the laundry while making sure not to exceed the

maximum load quantity indicated in the Wash Cycle Table.

- Pull out the detergent dispenser drawer and pour the detergent into the

relevant compartments as described in "DETERGENT DISPENSER

DRAWER" section.

- Close the door.

- Set the WASH CYCLE knob to the desired cycle.

- Modify the temperature: pressing the

reducing the temperature down to the cold wash level ( ).

- Select the desired wash cycle.

- Select the desired options.

- Press the START/PAUSE

button to start the wash cycle; the relative

indicator light will light up steady green and the door will lock (

light on).

PAUSING A CYCLE

To pause the wash cycle, press the START/PAUSE

indicator light will flash . If the

opened. To start the wash cycle from the point at which it was

interrupted, press the START/PAUSE

OPENING THE DOOR, IF NECESSARY

Once a cycle starts, the

indicator light turns on to signal that the door

cannot be opened. While a wash cycle is running, the door remains

locked. To open the door while a cycle is under way, for example, to add

or remove garments, press the START/PAUSE

cycle; the indicator light will flash . If the

door may be opened. Press the START/PAUSE

continue the cycle.

CHANGING A RUNNING WASH CYCLE

To change a wash cycle while it is in progress, pause the washer-dryer

using the START/PAUSE

button (the relative indicator light will flash ),

then select the desired cycle and press the START/PAUSE

again.

! To cancel a cycle that has already begun, press and hold the ON/OFF

button.

The cycle will be stopped and the machine will switch off.

END OF THE CYCLE

Once the cycle terminates the END indicator light will light up; when the

indicator light switches off, the door may be opened. Open the door,

unload the laundry and switch off the machine.If you do not press "ON/

OFF"

button, the washer-dryer will switch off automatically after about

a 10 minutes. Close the water tap, open the door and unload the washer-

dryer. Leave the door ajar to allow the drum to dry.

FUNCTIONS

- If the selected option is not compatible with the set wash cycle, the

indicator light will flash and the option will not be activated.

- If the selected option is not compatible with another previously

selected option, the indicator light will flash accompanied by a buzzer,

and only the latter option will be activated; the indicator light

corresponding to the activated option will turn on.

Stain removal

This option allows for selecting the type of dirt so as to optimally adjust the

cycle for removing the stains. The following types of dirt can be selected:

Food: for stains caused by foodstuffs and beverages, for example.

Work: for grease and ink stains, for example.

Outdoor: for mud and grass stains, for example.

! The wash cycle duration varies according to the type of selected dirt.

Slow Spin

By selecting this function, reduces the spin speed.

Extra rinse

By selecting this option, the efficiency of the rinse is increased and

optimal detergent removal is guaranteed. It is particularly useful for

sensitive skin.

Temperature

Each wash cycle has a pre-defined temperature. To modify the

temperature, press the

button.

Drying

Drying may be set as follows:

button. All the

button allows for gradually

button again; the

indicator light is not lit, the door may be

button again.

button to pause the

indicator light is not lit, the

button again to

button

indicator