Indesit WG1233TG Manuel d'instructions pour l'installation et l'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} Indesit WG1233TG. Indesit WG1233TG 13 pages. Indesit washing machine instructions for installation and use

Imprimer la page

Installation

Transit packing

After removing the packing, check the appliance for damage.

If you have any doubts do not use the washer and call a quali-

fied technician. Keep the packaging components (plastic bags,

polyester foam, nails etc.) out of the reach of children since

they could be dangerous. The interior of the washer, has an

oscillating unit which is fixed on the back by 2 screws during

transport (fig.1). Before starting up the washer, release the

unit, by unscrewing the 2 screws. Seal the screw holes with

the plastic plugs supplied with the appliance.

Fig. 1

Levelling

The washer must be perfectly levelled. To level the appliance,

only the front feet need to be adjusted (see fig. 2); remember

that the inclination of the working surface must not be more

than 2 degrees. If the washer is installed on a carpeted floor,

check that there is sufficient ventilation space between the

floor and the bottom of the washer.

Water supply

Both hot and cold water supplies are preferable and they

should be between 34.5kN/m²(5lb/in²) and 1034.2kN/m²

(150lb/in²) pressure. The hose with the red end piece must

be connected to the hot water supply and the connector

on the back of the appliance (see fig. 3), which is identified

by its red color or marked with the letter H on the side. The

hose with the white end piece must be connected to the

cold water supply and the connector on the back of the

appliance (see fig. 3), which is identified by its white color or

the letter C on the side. Remember to insert a sealing washer

at each connection to ensure watertight joints. Do not

overtighten the connections by using tools -hand tight is

sufficient to prevent leaks. It is generally more convenient to

have these supplies away from the sink taps. Where no

suitable hot water supply is available or it does not meet

these requirements, both inlet hoses may be connected to a

cold supply by using two taps etc., or a «T» junction on the

plumbing (see fig. 4) however, use of cold water only will

increase programme times.

Note: the maximum temperature should not exceed 70°C

(158°F).

Fig. 2

Fig. 3

Drain hose

The drain hose (hooked pipe) is secured to the rear of the

machine by support clips and may be routed to right or left

as required (see fig. 5). The drain hose should be placed in a

stand pipe with a minimum internal diameter of 38 mm (1½

inches) or it can be positioned over a sink (see fig. 6) or it

can be connected as shown in fig. 7. The height of stand

pipe or sink should be between 60 and 100 cm (24 and 40

inches). Care must be taken that the hose is not obstructed,

twisted, submerged or kinked. If the hose is connected with

an airtight joining, provision should be made to prevent

syphoning.

Fig. 5

Fig. 7

Fig. 4

Fig. 6