AEG AGE62526NX Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG AGE62526NX. AEG AGE62526NX 12 pages.

Imprimer la page

www.aeg.com

Problem

Water flows on the floor.

Temperature cannot be set. The FROSTMATIC or

DEMO appears on the dis-

play.

The temperature in the ap-

pliance is too low/too high.

Side panels of the appli-

ance are warm.

Door does not open easily.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

7. INSTALLATION

WARNING!

Refer to Safety chapters.

Possible cause

The melting water outlet is

not connected to the evap-

orative tray above the com-

pressor.

COOLMATIC function is

switched on.

The appliance is in demon-

stration mode.

The temperature regulator

is not set correctly.

The food products temper-

ature is too high.

The FROSTMATIC function

is switched on.

This is a normal state

caused by operation of the

heat exchanger.

You attempted to re-open

the door immediately after

closing.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

Solution

Attach the melting water out-

let to the evaporative tray.

Switch off FROSTMATIC or

COOLMATIC manually, or wait

until the function resets auto-

matically to set the tempera-

ture. Refer to "FROSTMATIC

or COOLMATIC function".

Keep the OK pressed for ap-

proximately 10 seconds until a

long sound is heard and dis-

play shuts off for a short time.

Set a higher/lower tempera-

ture.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Refer to "FROSTMATIC func-

tion".

Make sure that there is at least

30 mm of space between each

side of the appliance and the

surrounding furniture when

the ambient temperature ex-

ceeds 38°C.

Wait a few seconds between

closing and re-opening of the

door.