AEG ARCTIS Manuel d'utilisation - Page 7

Installation

The appliance should be set up in a well ventilated, dry room.

Energy use and efficient performance of the appliance is affected by

the ambient temperature.

The appliance should therefore

– not be exposed to direct sunlight;

– not be installed next to radiators, cookers or other sources of heat;

– only be installed at a location whose ambient temperature

corresponds to the climate classification, for which the appliance is

designed.

The climate classification can be found on the serial plate, which is

located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for

each climate classification:

Climate classification

If installation next to a source of heat is unavoidable, the following

minimum clearances must be maintained at the sides of the appliance:

– for electric cookers 3 cm;

– for oil and coal fired ranges 30 cm.

If these clearances cannot be maintained a heat insulating pad is

required between the cooker and the refrigeration appliance.

If the refrigeration appliance is installed next to another refrigerator

or freezer a clearance of 5 cm at the sides is required, in order to pre-

vent the formation of condensation on the outside of the appliance.

Your appliance needs air

Your freezer is designed for maintenance-free operation. What it

should never lack is good ventilation. Air is supplied under the ventila-

tion slot between the freezer and storage surface. Air is extracted

through the upper ventilation grille. Never obstruct these openings.

for an ambient temperature of

+10 to +32 °C

+16 to +32 °C

+18 to +38 °C

+18 to +43 °C