AEG ARCTIS Mode d'emploi et manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Mode d'emploi et manuel d'installation pour {nom_de_la_catégorie} AEG ARCTIS. AEG ARCTIS 28 pages. Built-in fridge-freezers
Également pour AEG ARCTIS : Manuel d'utilisation (32 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (28 pages), Instructions d'utilisation (16 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (26 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (27 pages), Manuel d'utilisation (34 pages), Manuel de l'utilisateur (24 pages), Manuel d'instructions d'installation (11 pages), Manuel d'utilisation (29 pages), Manuel d'utilisation (23 pages), Manuel d'instructions d'installation (25 pages), Manuel d'instructions d'installation (24 pages)

Electrical Connection

A properly installed socket outlet with earthing contact is required for

electrical connection. Electrical fuse protection must be of at least 10

ampere.

If the outlet socket is no longer accessible after installation of the

appliance, appropriate measures must be taken during electrical instal-

lation to assure that the appliance can be disconnected from the mains

(e.g. fuse, circuit breaker, non-operate current safety-switch or the like,

with a contact opening of at least 3 mm).

1. Before initial start-up, refer to the appliance rating plate to ascertain if

supply voltage and current values correspond with those of the mains

at the installation location.

e.g.:

AC 220 ... 240 V 50 Hz or

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance at the left.

Warning: To avoid potential danger, if the mains connection lead of

this appliance is damaged, it must be replaced by our customer service

representative or a person with similar qualifications.

Warning: Under no circumstances should the appliance be connected

to electronic "power saving plugs" or to a.c.-d.c. converters which con-

vert direct current to 230 V alternating current (e.g., solar installations,

ship networks)

The door hinges can be changed from right (as supplied) to left if

required to suit the location where the appliance is installed.

Warning! Unplug from the mains before reversing the door.

Open the door and remove the

plinth cover to the front. Move

the door bearing cover on the

plinth cover from the left to the

right. Close the door.

818 2113-00/4

220 ... 240 V~50 Hz