AEG ARCTIS Manuel de l'utilisateur - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG ARCTIS. AEG ARCTIS 24 pages. Built-in fridge-freezers
Également pour AEG ARCTIS : Manuel d'utilisation (32 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (28 pages), Instructions d'utilisation (16 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (26 pages), Mode d'emploi et manuel d'installation (28 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (27 pages), Manuel d'utilisation (34 pages), Manuel d'instructions d'installation (11 pages), Manuel d'utilisation (29 pages), Manuel d'utilisation (23 pages), Manuel d'instructions d'installation (25 pages), Manuel d'instructions d'installation (24 pages)

Imprimer la page
AEG ARCTIS Manuel de l'utilisateur
The freezer temperature is
not sufficient, red light
blinks, temperature alarm
signal sounds.
The compressor does not
start immediately after
changing the temperature
setting.
Important: regularly check on the red temperature pilot light and
thermometer to establish that the storage temperature is being main-
tained.

Noises during Operation

The following noises are characteristic of refrigeration appliances:
• Clicks
Whenever the compressor switches on or off, a click can be heard.
• Humming
As soon as the compressor is in operation, you can hear it humming.
• Bubbling/Splashing
When refrigerant flows into thin tubes, you can hear bubbling or
splashing noises. Even after the compressor has been switched off,
this noise can be heard for a short time.
40
Symptom
Possible Cause
Temperature is not proper-
ly adjusted.
Door was open for an
extended period.
A large quantity of warm
food placed in the appli-
ance within the last 24
hours.
The appliance is near a
heat source.
This is normal, no error has
occurred.
Remedy
Please look in the "Initial
Start Up" section.
Do not leave the door
open any longer than nec-
essary. Press the fast freeze
switch.
Press the fast freeze
switch.
Please look in the
"Installation Location"
section.
The compressor starts after
a period of time.