AEG K 818 40 i Instructions d'utilisation et d'installation - Page 15
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} AEG K 818 40 i. AEG K 818 40 i 28 pages. Integrating fridge freezer
Symptom
The compressor does not start
immediately after changing
the temperature setting.
Water on the floor or on sto-
rage shelves.
If, after carrying out the necessary checks there is still a fault with your
appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have
been made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service
calls.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it. Light bulb data: 220-240 V,
max. 15 W
1.
To switch off the appliance, turn the
temperature control knob to position
"0".
2.
Unplug the mains plug.
3.
To change the light bulb, remove the
screw from the light bulb cover.
4.
Unhook the light bulb cover as
shown.
5.
Change the defective light bulb.
6.
Refit the light bulb cover and the
screw.
7.
Put the refrigerator back into opera-
tion.
Possible Cause
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
AEG65
15