AEG SD14FS Manuel de l'utilisateur - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG SD14FS. AEG SD14FS 44 pages.

Imprimer la page

Problem

There is too much con‐

densed water on the rear

wall of the refrigerator.

Water flows inside the refrig‐

erator.

Water flows on the floor.

Temperature cannot be set.

The temperature in the appli‐

ance is too low/too high.

Possible cause

Door was opened too fre‐

quently.

Door was not closed com‐

pletely.

Stored food was not wrap‐

ped.

Food products prevent the

water from flowing into the

water collector.

The water outlet is clogged.

The melting water outlet is

not connected to the evapo‐

rative tray above the com‐

pressor.

The "Frostmatic function" is

switched on.

The temperature is not set

correctly.

The door is not closed cor‐

rectly.

The food products' tempera‐

ture is too high.

Many food products are stor‐

ed at the same time.

The thickness of the frost is

greater than 4-5 mm.

The door has been opened

often.

The Frostmatic function is

switched on.

ENGLISH

Solution

Open the door only when

necessary.

Make sure the door is closed

completely.

Wrap food in suitable pack‐

aging before storing it in the

appliance.

Make sure that food prod‐

ucts do not touch the rear

plate.

Clean the water outlet.

Attach the melting water out‐

let to the evaporative tray.

Switch off "Frostmatic func‐

tion" manually, or wait until

the function deactivates au‐

tomatically to set the temper‐

ature. Refer to "Frostmatic

function" section.

Set a higher/lower tempera‐

ture.

Refer to "Closing the door"

section.

Let the food products tem‐

perature decrease to room

temperature before storage.

Store less food products at

the same time.

Defrost the appliance.

Open the door only if neces‐

sary.

Refer to "Frostmatic func‐

tion" section.