AEG 2060 D Manuel d'utilisation et d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} AEG 2060 D. AEG 2060 D 19 pages. Electrolux cooker hood operating and installation instructions 2060 d
Également pour AEG 2060 D : Instructions d'utilisation et d'installation (20 pages), Manuel d'utilisation et d'installation (19 pages)
Imprimer la page
Filter checking device for the detection of
grease and active carbon
This type of vapour hood is predisposed with a device that signals
when the grease or active carbon filter requires cleaning (sold with the
active carbon filter by the manufacturer specialized in ventilation
equipment).
This type of vapour hood is supplied by the manufacturer without the
active carbon filter, therefore the saturation signal is disabled.
The hood is purchased with active carbon filter included, and the
saturation signal is activated as follows:
Depress and hold the A and B buttons simultaneously for 3 seconds.
Initially only the LED indicator signal for the grease filter C is
activated, shortly after the LED indicator for the active carbon filter D
will activate, at this point the saturation detection has been enabled.
To switch off the saturation detection : depress and hold the A and B
buttons for 3 seconds until the LED indicator for the active carbon filter
is flashing.
Led – Indicator for grease filter C
The LED indicator for the grease filter will flash when it requires
cleaning.
Follow the maintenance instructions.
Led - indicator for active carbon filter D
The LED indicator for the active carbon filter illuminates when the filter
requires replacing.
This occurs after about 160 working hours from when the active
carbon filter was first put into operation.
Resetting the saturation indicator
After cleaning the filter depress and hold the G and H buttons again
for 3 seconds until the LED – grease filter indicator or the LED – active
carbon indicator D are no longer flashing.
56