AEG 860 D Manuel d'instructions pour l'installation et l'utilisation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} AEG 860 D. AEG 860 D 24 pages. Build-in chimney fume extractor hood
Également pour AEG 860 D : Manuel d'instructions pour l'installation et l'utilisation (24 pages), Manuel d'utilisation (28 pages), Manuel d'instruction (28 pages)

MHW1

5/90

GB/EU

Remove the previously available exhaust air hose!

6. Installing the chimney equalizer (Fig. EO/1) flush with the

ceiling

Drill holes to take plugs for 5 x 30 mm screws on the RH and

LH sides of the fume extractor hood 50 mm from the lower

edge of the ceilling and screw in the screws until they are

5 mm away from the wall. `

Turn back the set-screw to its fullest extent by turning to the

lett.

Mount the chimney equalizer (Fig. EO/6) via the wall screws.

Screw in the set-screws by turning to the right until the chim-

ney equalizer is applied flush with the ceiling edge.

Maximum equalization height 2.55 m

Pull off the foil on the double adhesive tape above in the

chimney cover plate (Fig. EO/7).

. Slide the chimney cover plate (Fig. EO/2) (with the lateral

ventilation grille) (Fig. EO/8) from the front on to the fume

extractor hood until it engages the holders in the RH and LH

sides.

Firmly press upwards against the chimney equalizer (con-

nection by double adhesive tape).

FIX chimney cover plate (Fig. E0/2) laterally with 4 2.9 x 6.5

mm sheet metal screws on the chimney retaining plate.