AEG 860 D Manuel d'instructions pour l'installation et l'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} AEG 860 D. AEG 860 D 24 pages. Build-in chimney fume extractor hood
Également pour AEG 860 D : Manuel d'instructions pour l'installation et l'utilisation (24 pages), Manuel d'utilisation (28 pages), Manuel d'instruction (28 pages)

Imprimer la page

For the

electrical

installer

For the kitchen

. furniture

installer

Safety instructions

Arrangement of the protective contact plug socket inside the

chimney cover plate (Fig. EO/2) confers two advantages:

1. The plug socket is not visible.

2. You can easily de-energize the appliance where necessary

by unplugging it.

For the necessary fixed connection, the fume extractor hood

may be connected only by an electrical installer registered with

the electricity board covering your area. An isolating device is to `

be provided on the fixed wiring side.

Switches with a contact opening of more than 3 mm also apply

as isolating devices. These

include line protection switches,

fuses, and contactors (VDE 0730, s. 7, Part 1).

Connection

220 V~ via fixed supply lead with protective contact plug (Eu-

ropa version).

240 V~ via fixed supply lead (UK).

(Fixed connection to be made only by an approved electrical `

installer)

This appliance complies with the radio interference suppression

requirements of EC Directives 76/889 EC and 82/499 EC.

The exhaust air may not be introduced into a smoke flue or

exhaust gas chimney.

|. Introduction of the exhaust air into a shaft bad for ventilation

of the installation spaces of firerooms is not permitted.

If the exhaust air is introduced into a non-operational smoke

fiue or exhaust gas chimney, it is advisable to seek the con-

sent of the competent chimney-sweep.

The official exhaust air guidance regulations are basically to

be complied with.

During operation as an exhaust air appliance, an adequate

supply air opening of approximately the same size as the ex-

haust air opening is to be ensured.

According to the Provinciai Building Regulations, the joint op-

eration

of fume

extractor

hoods

and chimney-linked

fire-

places, such as coal- or oil-fired ovens and gas heaters, in the

same space is subject to specific restrictions.

In such spaces, the Fireplace Regulations only allow an under-

pressure of max. 0.04 mbar.

The safe joint operation of chimney-linked

appliances

and

fume

extractor

hoods

is only guaranteed

if space

and/or

dwelling (space/air interaction) are externally ventilated by a

suitable supply air opening of around 500—600 cm? and an

underpressure thereby avoided when the fume extractor hood

is running.

SIE2

5/80

— SIKM1

14/89

GB/EU