AEG 8609 D Manuel d'instructions pour l'installation et l'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} AEG 8609 D. AEG 8609 D 24 pages. Build-in chimney fume extractor hood
Également pour AEG 8609 D : Manuel d'instructions pour l'installation et l'utilisation (24 pages), Manuel d'utilisation (28 pages), Manuel d'instruction (28 pages)
MHW1
5/90
GB/EU
Remove the previously available exhaust air hose!
6. Installing the chimney equalizer (Fig. EO/1) flush with the
ceiling
Drill holes to take plugs for 5 x 30 mm screws on the RH and
LH sides of the fume extractor hood 50 mm from the lower
edge of the ceilling and screw in the screws until they are
5 mm away from the wall. `
Turn back the set-screw to its fullest extent by turning to the
lett.
Mount the chimney equalizer (Fig. EO/6) via the wall screws.
Screw in the set-screws by turning to the right until the chim-
ney equalizer is applied flush with the ceiling edge.
Maximum equalization height 2.55 m
T:
Pull off the foil on the double adhesive tape above in the
chimney cover plate (Fig. EO/7).
. Slide the chimney cover plate (Fig. EO/2) (with the lateral
ventilation grille) (Fig. EO/8) from the front on to the fume
extractor hood until it engages the holders in the RH and LH
sides.
Firmly press upwards against the chimney equalizer (con-
nection by double adhesive tape).
FIX chimney cover plate (Fig. E0/2) laterally with 4 2.9 x 6.5
mm sheet metal screws on the chimney retaining plate.
37