AEG DD 8794 Instructions d'utilisation et d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} AEG DD 8794. AEG DD 8794 18 pages. Electrolux cooker hood range hood models dd 8794 dd 8795 chdd 8795 operating and installation instructions
Également pour AEG DD 8794 : Manuel d'utilisation et d'installation (17 pages), Manuel d'utilisation et d'installation (22 pages), Instructions d'utilisation et d'installation (20 pages), Instructions d'utilisation et d'installation (22 pages)

Switching on the hood - Fig. 3

The control ball is a balancer switch.

Depressing the control ball repeatedly towards the

bottom, switches on the hood and you may select

the motor level desired, depressing once again the

hood switches off.

Switching on the light - Fig. 3

Depress the control ball towards the top :

once for submersed lighting,

once again for full lighting,

depress again to switch off the light.

Indicator light for grease or

charcoal filter

The air duct, in this hood, includes a device that

signals when the filter requires cleaning or

changing .

The LED signal flickers (flickering green light) when the grease filter

requires cleaning, occurs at about 40 operating hours.

Ensure that the indicator light is checked each time the hood is used.

The LED signal flickers (flickering orange light) when

requires cleaning, occurs at about 160 operating hours.

Ensure that the indicator light is checked each time the hood is used.

After cleaning or replacing the filter, select the intensive speed (the

control ball lights up with a red flashing light), depress again and hold

depressed for about 3 seconds until an audible signal indicates the

reset has taken place.

depress towards the

bottom to switch on

the hood.

depress towards

the top to switch

on the lights

Fig. 3

the charcoal filter