Kohler 1.1785.005 Manuel d'installation - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Kohler 1.1785.005. Kohler 1.1785.005 41 pages. Thermostatic electric shower

Imprimer la page

BEAB Care In-Service Tests

The BEAB Care In-Service Tests apply to products operated and maintained within

the BEAB Care approval requirements.

To maintain the validity of the BEAB Care mark, the installation and appliance should

be inspected regularly. The purpose of the in-service tests is to monitor and record

the performance of the shower. Any deterioration in performance can indicate the

need for maintenance work on the appliance and/or the water supplies.

Frequency of Inspections

Upon the initial installation of the shower and after any major repair work, the in-service tests

must be performed and the results recorded on the BEAB Care In-Service Test Record.

The shower should be tested again within 6 to 8 weeks after installation or any

major repair.

If there is no significant change in the outlet water temperature greater than ±1º C

between the two inspections, the in-service test frequency may be reduced but must

not exceed 12 months between any two inspections.

Equipment Required

The following equipment or suitable equivalent will be required in order for the tests

to be performed:

Digital Multimeter

100 mm diameter plastic funnel

Digital liquid thermometer accurate to 0.1º C

2 - 22 l/min flow measure cup

Pass/ Fail Criteria

If the outlet water temperature measured in step 14 has changed by more than 1º C

since the previous inspection. The shower, showerhead, hose and inlet filter should

be checked for blockages and cleaned and descaled or if required renewed. Checks

should also be performed to confirm that, the maximum temperature setting has not

been changed, any check valves or other backflow prevention devices are working

correctly and that any isolating valves in the supply pipework are fully open. The

shower should be recommissioned and re-tested.

If either of the outlet water temperature measurements are more than 2º C above the

maximum temperature setting this is considered to be a failure, the shower must

not be used, until the fault has been rectified and the product successfully re-tested.

1306246-W2-D