Purge Mode
Operating Your Bath with Airjets
User Keypad Buttons
On/Off - Turns the blower motor on and off. Pressing the switch once starts the blower motor at a
midrange speed. Pressing the button again stops the blower motor. The blower motor automatically
stops after about 20 minutes of operation. The blower motor can be restarted by pressing the
On/Off button.
Purge Mode - Initiates the purge cycle manually. The purge cycle blows any residual water out of
the air channels after the bath has been drained. Pressing the button once starts the blower motor at
low-speed. The blower motor stops automatically after about two minutes. Pressing the button
again before the cycle ends will stop the blower motor. Note that this product also has an automatic
purge cycle, which initiates about 30 minutes after the blower has stopped.
Increase Flow - Increases the air flow.
Decreases Flow- Decreases the air flow.
Operating Your Bath with Airjets
Close the drain, and fill the bath to a level at least 4" (10 cm) above the top of the highest air jets.
Use your hand to test the water temperature for comfort and safety, then carefully enter the bath
basin.
Press the power button to turn on the bath with airjets.
NOTE: The bath with airjets includes a timer that stops the air system after approximately 20 minutes of
continuous operation. You can then restart the bath if you desire by pressing the power button.
If desired, press the up or down buttons to change the rate of airflow.
When finished, press the power button a second time to turn off the bath.
Carefully exit the bath, and open the drain to empty the bath.
About 30 minutes after the air system stops, the bath with airjets performs an automatic two-minute
purge cycle.
NOTE: If the bath with airjets does not function properly, please refer to "Troubleshooting" section.
1034591-5-J
On/Off
4
Increases Flow
Decreases Flow
Kohler Co.
Imprimer la page