AEG 916 098 987 Manuel de l'utilisateur - Page 22
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG 916 098 987. AEG 916 098 987 32 pages.
Imprimer la page
22
www.aeg.com
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion.
11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 Error Codes
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause button may flash continuously:
Possible cause
E5A
E97
EH0
If the display shows other alarm codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the Tumble dryer check the table below for possible
solutions.
Possible cause
Appliance Motor overloaded.
Too much laundry or entrap in the
drum.
Internal fail. No communication be‐
tween electronic elements of the
appliance.
The mains supply is unstable.
10.6 Cleaning the airflow
slots
Use a vacuum cleaner to remove fluff
from the airflow slots.
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the alarm code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Remedy