Kohler K-1194 Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Kohler K-1194. Kohler K-1194 48 pages. Bath whirlpool
Également pour Kohler K-1194 : Manuel du propriétaire (32 pages), Manuel d'installation (44 pages), Manuel d'installation (48 pages)

Imprimer la page

10. Test Run the Whirlpool

Check all electrical connections, and make sure the electrical power to the whirlpool and heater (if

equipped) is on.

Make sure all union connections to the pump and heater are securely hand tightened.

Verify that the pump banding straps have been cut (if applicable), and that the pump is resting

directly on the subﬂoor or whirlpool base.

Fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.

Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

For additional information on whirlpool operation, refer to "Conﬁrm Proper Operation."

11. Complete the Finished Wall

If you have not already done so, carefully remove the protective tape from the whirlpool rim.

Cover the framing with water-resistant wall material.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material.

Seal the joints between the whirlpool rim and the ﬁnished wall material with silicone sealant.

Install the faucet trim according to the instructions packed with the trim.

12. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

whirlpool surface. Use warm water and a liquid detergent to clean the surface.

Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners

containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods

of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire

brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild

abrasive action to any residual plaster.

1055820-2-A

Apply silicone sealant to the

Finished Deck

edges of the water-resistant

Material

deck material and the

finished deck.

Whirlpool

Drop-In Installation

Water-Resistant

Deck Material

Framing Material

Kohler Co.