AEG HE 260 T Instructions d'utilisation et d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} AEG HE 260 T. AEG HE 260 T 38 pages.

Operation instructions

1.1

The automatically operating AEG HE 181, HE 260 T and HE 260 TM hand dryers are fitted with a

proximity switch which activates the fan when your hands are brought towards it, (approximately

60 - 120 mm below the warm air exit grille). The dryer automatically switches off approximately

3 seconds after the hands have moved away from the sensor.

The casing design does not allow cigarettes or drinks etc to be placed on top, causing a hazard. To

retain this feature, when assembling ensure that there are no gaps between the wall and the unit.

In addition, the HE 260 TM is protected against damage by the cast aluminium casing.

1.2

In order to save energy and shorten the drying time, vigorously shake wet hands over the

washbasin, then hold your hands beneath the air exit grille rubbing them together in the warm

airstream.

1.3

During operation, temperatures of over 90 °C can occur at the warm-air exit grille. Due to

the risk of overheating this should not be covered.

In the event of overheating the temperature safety cut out switches off the heating element and

the fan continues to run in a cooling mode. The heating element switches back on after

approximately two minutes.

Ensure that the air inlet grilles on the underside and rear of the dryer are always kept open.

Trouble-free function and operational safety can only be guaranteed if the original AEG

accessories and spare parts are used.

1.4

When cleaning the casing, only use a soft cloth, with a mild detergent if necessary, and repolish

with a soft cloth. Do not spray the dryer with water or use any abrasive or caustic cleaning agents.

1.5

Like all proximity switches, the operation of the sensor is impaired if it is covered. If this happens

the hand dryer automatically switches off after 3 seconds preventing it from running continuously.

In the event of an operating failure, check that the sensor has not been covered. After the removal

of any objects the dryer should function as normal.

For the User