Kohler K-1257 Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Kohler K-1257. Kohler K-1257 48 pages. Bath whirlpool
Également pour Kohler K-1257 : Manuel du propriétaire (32 pages), Manuel du propriétaire (29 pages), Manuel d'installation (48 pages), Manuel du propriétaire (36 pages), Manuel du propriétaire (32 pages), Manuel d'installation (48 pages), Manuel d'installation (4 pages), Manuel d'installation (4 pages), Manuel d'installation (48 pages), Manuel d'installation (4 pages), Manuel d'installation (44 pages), Manuel d'installation (44 pages), Manuel du propriétaire (29 pages), Manuel d'installation (4 pages), Manuel d'installation (48 pages)

Imprimer la page

Purge Mode

13. Troubleshooting Procedure

Troubleshooting Guide

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Symptoms

Bath with airjets does not

start.

2. Blower motor starts, but

there are few or no

bubbles.

3. Bath stops automatically

before 18 minutes.

4. Bath does not stop

automatically after 22

minutes.

5. Blower motor does not

stop when power button

on user keypad is

pressed.

6. Blower motor operates

but variable speed feature

does not work.

1040292-2-E

On/Off

Probable Causes

A. No power to blower motor.

B. User keypad cable loose or

damaged.

C. User keypad does not work.

D. Blower motor does not work.

A. Blower motor is disconnected.

B. Blower motor air ﬂow is

restricted.

A. GFCI or ELCB trips.

B. Motor overheated and protection

device activated.

A. Blower motor does not work.

A. User keypad cable loose or

damaged.

B. User keypad does not work.

A. User keypad cable loose or

damaged.

B. User keypad does not work.

C. Blower motor does not work.

Recommended Action

A. Set/reset GFCI or ELCB breaker;

check wiring.

B. Check wire connections. If

necessary, replace user keypad

cable.

C. Check wire connections. Replace

user keypad.

D. Replace blower motor.

A. Connect blower motor to air

harness.

B. Clean the area around the blower

motor. Ensure adequate

ventilation.

A. Identify source of fault and

correct.

B. Check for blockage at motor

vents. Remove blockage and

allow motor to cool.

A. Replace blower motor.

A. Check wire connections. If

necessary, replace user keypad

cable.

B. Replace user keypad.

A. Check wire connections. If

necessary, replace user keypad

cable.

B. Replace user keypad.

C. Replace blower motor.

Increases Flow

Decreases Flow

Kohler Co.