AEG LAVATHERM 61270AC Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG LAVATHERM 61270AC. AEG LAVATHERM 61270AC 20 pages.
Également pour AEG LAVATHERM 61270AC : Manuel de l'utilisateur (44 pages), Manuel de l'utilisateur (24 pages)
Imprimer la page
• before you push the Start/Pause but-
ton - the appliance cannot start
• after you push the Start/Pause button
- all the push buttons and the pro-
gramme dial are deactivated
7.14 At the end of programme
When the drying cycle is completed, the
symbol flashes on the display. If the
Buzzer function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
8. HINTS AND TIPS
8.1 Ecological hints
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
8.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the re-
maining moisture of the laundry:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Delicate
and the Anticrease buttons. Hold
down until one of the symbols go in-
to view on the display:
–
the maximum dry laundry
1.
Push the On/Off button for 2 sec-
onds to deactivate the appliance.
2.
Open the appliance door.
3.
Remove the laundry.
4.
Close the appliance door.
After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
–
the more dry laundry
–
the default dry laundry
3.
Push the Start Pause button again
and again until you set necessary
level.
4.
To memorise the setting push at the
same time the Delicate and the Anti-
crease buttons.
8.3 Water container full —
indication
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED can
be off.
To activate or deactivate the indication:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Delicate
and Delay Start buttons and hold
down until you see the correct set-
ting:
– the LED is off and the symbol
goes into the view - The
LED is permanently off
– the LED is on and the symbol
goes into the view - The
LED is activated
ENGLISH
11