AEG LAVATHERM T56830 Informations sur l'utilisateur - Page 23
Parcourez en ligne ou téléchargez le pdf Informations sur l'utilisateur pour {nom_de_la_catégorie} AEG LAVATHERM T56830. AEG LAVATHERM T56830 33 pages. Condensation dryer
Également pour AEG LAVATHERM T56830 : Informations sur l'utilisateur (33 pages)
Imprimer la page
Problem
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete").
Drying cycle ends
shortly after programme
starts. END display illumina-
ted.
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The special
bulb is available from the local Service Force Centre.
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly behind
the loading aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be operated.
Possible cause
Lint filter clogged.
Heat exchanger clogged
with lint.
SPECIAL CARE
button pressed and load
volume too big.
Load volume too big.
Laundry insufficiently pre-
drained.
Not enough washing loaded
or washing loaded is too
dry for selected programme.
Remedy
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE is only suita-
ble for use with
loads of up to 3,5 kg!
Reduce load volume.
Laundry must be adequately
pre-drained.
Select time programme or
higher drying level (e.g.
INTENSIVE DRY instead of
STORAGE DRY).
23