Kohler Intelligent Toilet Manuel du propriétaire - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Kohler Intelligent Toilet. Kohler Intelligent Toilet 49 pages.

Imprimer la page

Replacing the Batteries

NOTE: The red light on the docking station will blink when the batteries are low. The "stop" icon on the
remote control will blink when it has a low charge and should be returned to the docking station.
If the remote control is secured to the docking station, remove it and set aside.
Remove the docking station from the wall by carefully lifting up and out.
Open the back compartment on the docking station by pushing both tabs outward at the same time.
Install four AA batteries, oriented as shown in the battery compartment.
Reinstall the cover.
Reinstall the docking station on the wall.

Troubleshooting

NOTE: For service parts information, visit the product page at kohler.com/serviceparts.
Small Children
The automatic flush and cleansing features are activated by a sensor located under the seat. Small
children may not be tall enough to be detected by the sensor.
General
Symptoms
1.
The toilet beeps while
occupied.
2.
The toilet has no power.
3.
The toilet has power but
does not flush.
Kohler Co.
Back of Docking Station
Probable Causes
A. The seat has been occupied for
an extended period of time.
A. The power cord is not
connected.
B. The GFCI or RCD is tripped.
C. The toilet is in standby mode.
D. The internal switch is turned off. D. Remove the right side panel and
A. No water being supplied to the
toilet.
13
Recommended Action
A. No action required. This is simply
an indicator beep.
A. Connect the power cord.
B. Reset the GFCI or RCD.
C. Press any icon on the side control
panel to reactivate the toilet.
turn the internal switch on.
A. Fully open the water supply stop.
1295780-5-A