Kohler Command Pro CH980 Manuel du propriétaire - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Kohler Command Pro CH980. Kohler Command Pro CH980 21 pages. Horizontal/vertical shaft
Également pour Kohler Command Pro CH980 : Manuel du propriétaire (8 pages)
Imprimer la page
Air
Cleaner
Throttle
Control
Lever
Spark
Plug
Cylinder
Shrouds
Blower
Housing
Figure 1. Typical Command PRO Horizontal Shaft Engine.
Oil Recommendations
Using the proper type and weight of oil in the
crankcase is extremely important. So is checking oil
daily and changing oil regularly. It is also
recommended that a consistent brand of oil be used.
Failure to use the correct oil, or using dirty oil, causes
premature engine wear and failure.
Oil Type
Use high quality detergent oil of API (American
Petroleum Institute) service class SJ or higher. Select
the viscosity based on the air temperature at the time
of operation as shown in the following table.
R E CO M ME N DED SAE VISCOSITY GRAD E S
**
5W-20, 5W-30
°F -20
0
20
°C -30
-20
-10
TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE
* Use of synthetic oil having 5W-20 or 5W-30 rating is acceptable,
up to 4°C (40°F)
** Synthetic oils will provide better starting in extreme cold below
23°C (-10°F)
Figure 2. Viscosity Grades Table.
NOTE: Using other than service class SJ or higher oil
or extending oil change intervals longer than
recommended can cause engine damage.
4
Lifting Point
Oil Filter
Choke
Control
Lever
Screen
10W-30
*
Kohler 10W-30
32
40
60
80
100
0
10
20
30
Carburetor
Oil Fill
Dipstick
Electric
Starter
NOTE: Synthetic oils meeting the listed
classifications may be used with oil changes
performed at the recommended intervals.
However to allow piston rings to properly
seat, a new or rebuilt engine should be
operated for at least 50 hours using standard
petroleum based oil before switching to
synthetic oil.
A logo or symbol on oil containers identifies the API
service class and SAE viscosity grade. See Figure 3.
Figure 3. Oil Container Logo.
40
Refer to Maintenance Instructions beginning on page
8 for detailed oil check, oil change, and oil filter change
procedures.
Lifting
Strap
SAE
10W-30
Fuel
Pump
Oil
Drain
Plugs