Kohler Command Pro CV940 Manuel du propriétaire - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Kohler Command Pro CV940. Kohler Command Pro CV940 21 pages. Vertical
Également pour Kohler Command Pro CV940 : Manuel du propriétaire (8 pages)
Imprimer la page
• Make sure fuel is reaching the carburetor. This
includes checking the fuel lines and fuel pump for
restrictions or faulty components, replace as
necessary.
• Make sure the air cleaner element is clean and all
air cleaner element components are fastened
securely.
If, after checking the items listed above, the engine is
hard to start, runs roughly, or stalls at low idle speed,
it may be necessary to adjust or service the
carburetor.
Adjust Carburetor
Low Idle Speed (RPM) and Governed Idle
Adjustment.
1. Low Idle Speed (RPM) Setting: Place the throttle
control into the idle or slow position. Hold the
governor lever away from carburetor so the
throttle lever is against the Idle Speed (RPM)
Adjustment Screw of carburetor. See Figure 25.
Set the low idle speed to 1200 RPM* (± 75 RPM)
by turning the low idle speed adjusting screw on
carburetor in or out. Check the speed using a
tachometer.
*NOTE: The actual low idle speed depends on the
application. Refer to the equipment
manufacturer's recommendations. The low
idle speed for basic engines is 1200 RPM. To
ensure best results when setting the low idle
fuel needle, the low idle speed should be 1200
RPM (± 75 RPM).
2. Release the governor lever and check that the
throttle lever is in the idle position. Turn the
governed idle (outer) adjustment screw on main
control bracket to obtain the equipment
manufacturer's recommended idle speed (1400-
1800 RPM). See Figure 26.
Figure 26. Adjusting Governed Idle Speed Screw.
14
High Speed
Adjustment
Screw
Governed Idle
Speed Screw
Low Idle Fuel Adjustment
NOTE: Engines will have fixed low idle or limiter
caps on the two idle fuel adjusting needles.
Step 3 can only be performed within the
limits allowed by the cap. Do not attempt to
remove the limiter caps.
1. Start the engine and run at half throttle for 5 to 10
minutes to warm up. The engine must be warm
before doing steps 2, 3 and 4.
2. Place the throttle control into the idle or slow
position. Adjust the low idle speed to 1200 RPM*
Follow the Adjusting the Low Idle Speed (RPM)
procedure.
3. Low Idle Fuel Needle(s) Setting: Place the
throttle into the idle or slow position.
a. Turn one of the low idle fuel adjusting
needles out (counterclockwise) from the
preliminary setting until the engine speed
decreases (rich). Note the position of the
needle. Now turn the adjusting needle in
(clockwise). The engine speed may increase,
then it will decrease as the needle is turned
in (lean). Note the position of the needle. Set
the adjusting needle midway between the
rich and lean settings. See Figure 27.
b. Repeat the procedure on the other low idle
adjustment needle.
4. Recheck/adjust the Low Idle Speed (RPM), to the
specified setting.
Lean
Adjust to
Midpoint
Rich
Left Side
Figure 27. Optimum Low Idle Fuel Settings.
High Speed (RPM) Adjustment
The high speed RPM (inner/upper) adjustment screw
is preset at the factory and normally does not need
readjustment.
Lean
Adjust to
Midpoint
Rich
Right Side