Kohler 14/20RESAL Manuel d'installation - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Kohler 14/20RESAL. Kohler 14/20RESAL 44 pages. Residential/commercial generator sets

Imprimer la page

1.10.3 OnCue Home Generator

Management System

The OnCuer Home Generator Management System

allows monitoring and control of your generator set from

a personal computer located in your home or at other

remote locations. OnCue can also be configured to

send email or text message notifications in the event of a

generator set fault. See TP-6796, OnCue Software

Operation Manual, for software instructions.

The OnCue system is available separately as a loose kit.

Use category 5E network cable to connect the RDC2

controller to the customer-supplied Ethernet router and

cable or DSL modem.

low-voltage signal wiring (for example, the RBUS

communication leads or engine start leads to the

transfer switch), in separate conduit from the AC load

leads. If the network cable is longer than 100 meters

(328 ft.), use a repeater or switch.

Recommended: Use a laptop computer to verify the

network connection before connecting to the generator

set.

Checking the network connection

1. Check for and turn OFF any wireless connections

to the laptop.

2. Connect the network cable to the laptop. Connect

the other end of the network cable to the

customer's router or modem.

3. Verify the Internet connection by opening your web

browser and going to www.kohlerpower.com or

another website.

4. After verifying the connection through the network

cable, disconnect the network cable from the

laptop and turn the laptop wireless connections

back on.

TP-6803 12/11

Route the cable with other

Connect to the Ethernet cable in the customer

connection area of the generator set. See Figure 1-36.

Use an RJ45 inline coupler, provided with the OnCue kit,

to connect the customer's Ethernet cable to the cable in

the customer connection box.

1. Ethernet cable for optional OnCue connection

Figure 1-36 Network Connection for OnCue

GM84094

Section 1 Installation