Kohler 20EFKOZD Manuel d'instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Kohler 20EFKOZD. Kohler 20EFKOZD 8 pages.
Également pour Kohler 20EFKOZD : Manuel d'instructions d'installation (12 pages)
Imprimer la page
Installation Procedure
1.
Remove the generator set from service.
1.1
Press
the
generator
OFF/RESET button.
1.2
Disconnect the power to the battery charger, if
equipped.
1.3
Disconnect the generator set engine starting
battery, the negative (--) lead first.
2.
Remove the sound shield door and roof.
2.1
Remove the sound shield's engine-end (front)
door and roof (if necessary) to gain access to the
generator set hoses inside. See Figure 2.
1. Engine-end (front) door
2. Customer connection panel
3. Button plugs (qty. 2)
4. Roof
Figure 2 Sound Shield
2.2
Open the service doors.
2.3
Release/untighten the three wing nuts located
underneath the roof. See Figure 3.
2.4
Lift up the roof.
2.5
Slide the roof towards the service side of the unit
for removal.
2.6
Open the front, rear, and non-service side doors
as needed.
2
set
master
control
4
3
2
1
2
2
1. Sound shield roof
2. Wing nut
3. Service door
Figure 3 Sound Shield Roof Removal
3.
Install the siphon break.
3.1
Remove the 2 button plugs from the customer
connection panel. See Figure 2.
3.2
Install the 2 grommets (X-284-42) and 2 hose
connectors (344934) to the openings in the
customer connection panel. See Figure 8.
3.3
Find and remove the hose (X-312-49) located
between the heat exchanger end cap and the
exhaust mixer. Save the hose clamps, tee, and
pressure switch. Keep the elbow in position on the
exhaust mixer.
Nonservice-Side
1
1. Elbow on exhaust mixer (elbow not shown)
2. Tee, pressure switch, and hose clamps
3. Hose (X-312-49)
Figure 4 Hose Removal
1
2
GM89517
3
View
2
3
TT-1664
6/15